3D Design - Common Assembly Strategies for Additive Manufacturing

This video goes over a few simple but effective methods to assemble 3d printed parts. We cover a few key features in Solid Edge that makes assembling easy and also go over a dovetail joint.

Basic Motion Simulation in Solid Edge

3D printing electronics enclosures with HP Jet Fusion Technology

3D printing with HP Jet Fusion simplifies the process even further. There are zero supports required and assemblies can be printed in place. Common features we see are:

Implicit Modeling in NX

Implicit Modeling in NX

Solid Edge Technical Publications

If your company is struggling with the cost and time wasted on producing accurate technical documentation, perhaps it is time to look at Solid Edge Technical Publications.

Packing Density and Cost Per Part – The Impact of Mass Reduction

When 3D printing a powder bed technology (Jet Fusion, Selective Laser Sintering) one of the most important constraints to consider is the packing density of your build. Packing density refers to the percent of the build volume that is taken up by the printed parts themselves. Depending on your technology and application it is typical to see targets set at 6 – 12%.

Solid Edge Tips and Tricks (SEU)

Our annual Solid Edge Tips and Tricks presented at Solid Edge University 2021

NX Parting Lines Tips

NX Advanced curve and surface features; showing best-practice techniques to improve your mold parting-lines and run-offs.